jacking points Citroen C2 2007.5 1.G Owner's Manual

Page 123 of 191

V
122
C H A N G I N G A W H E E L
Removal1. Park the vehicle on stable, fi rm ground that is not slippery. Apply the parking brake.Switch off the ignition and engage fi rst gear or reverse gear, depending on any slope.2. Position the jack at one of the four jacking-points provided on the sub-frame close to the wheels. Using the handle, unwind the jack until it reaches the ground.3. To unclip the wheel embellisher, pull using the end of the wheelbrace as a lever in one of the apertures.For vehicles with aluminium wheel rims:
With a central embellisher, remove the embellisher, using the tool, to access the bolts.With visible wheel bolts, remove the chromed bolt protectors, usi ng the tool, before slackening the bolts.4. Continue to extend the jack until the wheel is a few centimetres off the ground.5. Undo the other bolts, remove the wheel.
-
-
Refi tting1. Fit the wheel on the hub, using the centring guide.2. Screw in the bolts but do not fully tighten them, remove the wheel centring guide in order to screw in the last bolt.3. Lower the jack and remove it.4. Tighten the wheel bolts, using the wheelbrace.5. Refi t the embellisher, taking care to accommodate the tyre valve . Then pressing all round its circumference.6. Have the original wheel repaired and refi tted as soon as possible.7. Make sure that the tyre is at the correct pressure (see “Vehicle Ident ifi cation” and “User Precautions”) and have the wheel balancing checked.
Dimension of the spare wheel
If your spare wheel has dimensions different from those of the normal vehicle wheels (identifi ed by a label), it is imperative to use the spare wheel only temporarily, to drive with caution, not to exceed 80 km/h (50 mph) and to have the tyre repaired and the normal wheel refi tted as soon as po ssible.